Dometic fridge
Dometic RM8 / RMD8 / RML8 fridge flashing light fault codes (MES & AES)
All 11 codes, what each one means and what to check, from Dometic RM 8xxx / RMS 8xxx / RML 8xxx / RMSL 8xxx operating manual (EMEA, EN section).
230V + fault LED flashing230 V mode: mains supply missing or voltage too low.
Source: Dometic RM 8xxx / RMS 8xxx / RML 8xxx / RMSL 8xxx operating manual (EMEA, EN section). Open the PDF
12V + fault LED flashing12 V mode: 12 V supply missing or voltage too low.
Source: Dometic RM 8xxx / RMS 8xxx / RML 8xxx / RMSL 8xxx operating manual (EMEA, EN section). Open the PDF
GAS + fault LED flashingGASGas or automatic mode: the flame did not light.
Gas fault: get a licensed gas fitter
Turn the gas off at the bottle and run the appliance on another power source until it's checked. Only a licensed gas fitter should work on the gas side.
Source: Dometic RM 8xxx / RMS 8xxx / RML 8xxx / RMSL 8xxx operating manual (EMEA, EN section). Open the PDF
Beep 15 s every 2 minInterior light is switched on - door left open.
Likely cause: Door not fully closed or door contact fault.
Dometic's checks, in order: Close the door and check the door contact.
Source: Dometic RMD8501, RMD8505, RMD8551, RMD8555 operating manual APAC (EN), page 26. Open the PDF
230V + temperature LED flashing230 V heating element defective (or cooling unit fault).
Source: Dometic RM 8xxx / RMS 8xxx / RML 8xxx / RMSL 8xxx operating manual (EMEA, EN section). Open the PDF
12V + temperature LED flashing12 V heating element defective (or cooling unit fault).
Source: Dometic RM 8xxx / RMS 8xxx / RML 8xxx / RMSL 8xxx operating manual (EMEA, EN section). Open the PDF
Temperature LED flashingTemperature sensor has no contact or is defective.
Source: Dometic RM 8xxx / RMS 8xxx / RML 8xxx / RMSL 8xxx operating manual (EMEA, EN section). Open the PDF
GAS + temperature LED flashingBurner defective or cooling unit defective.
Likely cause: Dirty or damaged burner or jet, or a failed cooling unit.
Dometic's checks, in order: Check the burner and jets; contact Dometic service for repair or replacement.
Parts these checks can point to
Source: Dometic RMD8501, RMD8505, RMD8551, RMD8555 operating manual APAC (EN), page 26. Open the PDF
GAS LED flashing brightly (battery mode)GASBattery-powered electronics: flame did not light.
Likely cause: Empty gas bottle or closed gas valve.
Gas fault: get a licensed gas fitter
Turn the gas off at the bottle and run the appliance on another power source until it's checked. Only a licensed gas fitter should work on the gas side.
Dometic's checks, in order: Check gas supply, then press the fault/reset button once fixed.
Parts these checks can point to
Source: Dometic RMD8501, RMD8505, RMD8551, RMD8555 operating manual APAC (EN), page 27. Open the PDF
GAS + temperature LED flashing brightly (battery mode)Battery-powered electronics: burner or cooling unit defective.
Likely cause: Dirty or damaged burner, or failed cooling unit.
Dometic's checks, in order: Check burner and jets; contact Dometic service.
Parts these checks can point to
Source: Dometic RMD8501, RMD8505, RMD8551, RMD8555 operating manual APAC (EN), page 27. Open the PDF
Beep every 15 s (battery mode)Internal batteries are running low (undervoltage).
Likely cause: Electronics batteries in the fridge are flat.
Dometic's checks, in order: Replace the internal batteries.
Source: Dometic RMD8501, RMD8505, RMD8551, RMD8555 operating manual APAC (EN), page 27. Open the PDF
Where this comes from
Dometic RM 8xxx / RMS 8xxx / RML 8xxx / RMSL 8xxx operating manual (EMEA, EN section), published by Dometic. Open the PDF
We don't invent fault codes or part numbers. Each code above carries the page it came from.