SparePartsMatcher

Dometic fridge

Dometic RMDX21 / RMDX25 fridge fault indications

All 8 codes, what each one means and what to check, from Dometic RMDX21 / RMDX25 operating manual (APAC, EN).

AC + temperature flashing, 20 s beepAC heater element or cooling unit is defective.

Likely cause: Failed 230 V heater element or cooling unit.

Dometic's checks, in order: Contact an authorised Dometic service agent.

Source: Dometic RMDX21 / RMDX25 operating manual (APAC, EN), page 36. Open the PDF

DC + temperature flashing, 20 s beepDC heater element or cooling unit is defective.

Likely cause: Failed 12 V heater element or cooling unit.

Dometic's checks, in order: Contact an authorised Dometic service agent.

Source: Dometic RMDX21 / RMDX25 operating manual (APAC, EN), page 36. Open the PDF

Flame + temperature flashing, 20 s beepBurner or cooling unit is defective.

Likely cause: Dirty or failed burner, or failed cooling unit.

Dometic's checks, in order: Contact an authorised Dometic service agent.

Source: Dometic RMDX21 / RMDX25 operating manual (APAC, EN), page 36. Open the PDF

Temperature indicator flashingTemperature sensor has no contact or is defective.

Likely cause: Sensor unplugged, damaged or failed.

Dometic's checks, in order: Contact an authorised Dometic service agent.

Parts these checks can point to

Source: Dometic RMDX21 / RMDX25 operating manual (APAC, EN), page 36. Open the PDF

AC + fault flashing, 20 s beepAC operation: mains supply missing or insufficient.

Likely cause: No mains, low voltage, or blown fuse.

Dometic's checks, in order: Check the AC power cable, supply and fuse.

Source: Dometic RMDX21 / RMDX25 operating manual (APAC, EN), page 36. Open the PDF

DC + fault flashing, 20 s beepDC operation: 12 V supply missing or insufficient.

Likely cause: Flat vehicle battery, wiring fault or blown fuse.

Dometic's checks, in order: Check the DC cable, vehicle battery and fuse.

Source: Dometic RMDX21 / RMDX25 operating manual (APAC, EN), page 36. Open the PDF

Flame + fault flashing, 20 s beepGASGas or auto operation: burner flame did not ignite.

Likely cause: Empty gas cylinder or closed gas valve.

Gas fault: get a licensed gas fitter

Turn the gas off at the bottle and run the appliance on another power source until it's checked. Only a licensed gas fitter should work on the gas side.

Dometic's checks, in order: Check gas supply, then press the fault button once fixed.

Source: Dometic RMDX21 / RMDX25 operating manual (APAC, EN), page 36. Open the PDF

Beep 15 s every 2 minInterior light is on - door not closed.

Likely cause: Door not properly closed.

Dometic's checks, in order: Check and close the refrigerator door.

Source: Dometic RMDX21 / RMDX25 operating manual (APAC, EN), page 36. Open the PDF

Where this comes from

Dometic RMDX21 / RMDX25 operating manual (APAC, EN), published by Dometic. Open the PDF

We don't invent fault codes or part numbers. Each code above carries the page it came from.