Aircommand air conditioner
Aircommand Sandpiper air conditioner error codes
All 8 codes, what each one means and what to check, from Aircommand Sandpiper owners manual / installation guide (Rev 7, 28 May 2013).
E1Return-air (room) temperature sensor fault.
Likely cause: Sensor unplugged, damaged lead or failed sensor.
Aircommand's checks, in order: Contact Aircommand Australia or an authorised service agent.
Source: Aircommand Sandpiper owners manual / installation guide (Rev 7, 28 May 2013), page 20. Open the PDF
E2Inside coil temperature sensor fault.
Likely cause: Sensor unplugged, damaged lead or failed sensor.
Aircommand's checks, in order: Contact Aircommand Australia or an authorised service agent.
Source: Aircommand Sandpiper owners manual / installation guide (Rev 7, 28 May 2013), page 20. Open the PDF
E3Outside coil temperature sensor fault.
Likely cause: Sensor unplugged, damaged lead or failed sensor.
Aircommand's checks, in order: Contact Aircommand Australia or an authorised service agent.
Source: Aircommand Sandpiper owners manual / installation guide (Rev 7, 28 May 2013), page 20. Open the PDF
E4Inside coil is not cooling.
Likely cause: Compressor not running or low refrigerant.
Aircommand's checks, in order: Contact Aircommand Australia or an authorised service agent.
Source: Aircommand Sandpiper owners manual / installation guide (Rev 7, 28 May 2013), page 20. Open the PDF
E5Outside coil over temperature.
Likely cause: Condenser airflow blocked or condenser fan not running.
Aircommand's checks, in order: Contact Aircommand Australia or an authorised service agent.
Parts these checks can point to
Source: Aircommand Sandpiper owners manual / installation guide (Rev 7, 28 May 2013), page 20. Open the PDF
E15Communication error between control pad and main board.
Likely cause: Loose connection or failed control pad.
Aircommand's checks, in order: Check connections or replace the control pad; contact Aircommand Australia.
Source: Aircommand Sandpiper owners manual / installation guide (Rev 7, 28 May 2013), page 20. Open the PDF
E18Ambient temperature sensor error.
Likely cause: Sensor or wiring fault.
Aircommand's checks, in order: Contact Aircommand Australia or an authorised service agent.
Source: Aircommand Sandpiper owners manual / installation guide (Rev 7, 28 May 2013), page 20. Open the PDF
E21Outdoor air temperature sensor error.
Likely cause: Sensor or wiring fault.
Aircommand's checks, in order: Contact Aircommand Australia or an authorised service agent.
Source: Aircommand Sandpiper owners manual / installation guide (Rev 7, 28 May 2013), page 20. Open the PDF
Where this comes from
Aircommand Sandpiper owners manual / installation guide (Rev 7, 28 May 2013), published by Aircommand. Open the PDF
We don't invent fault codes or part numbers. Each code above carries the page it came from.