Where to find the model number on a Truma heater
Truma heaters carry a type plate on the heater casing. The heater is often hidden under a bed or seat, so Truma supplies a duplicate type plate with a removable barcode, and installers are told to stick it somewhere visible.
What each line on the plate means
Appliance type / Heater type
Model name, e.g. Combi 4 E, Combi D 6, VarioHeat comfort, S 3004.
On the plate: Combi D 6
Serial no.
On newer labels this is one string: device information + series letter + device ID (GID).
On the plate: SHG03EU-D-34172001 (S 3004 example)
Year of first commissioning (tick boxes)
The installer ticks the year the heater was first used, which gives you its age.
On the plate: 2023 | 2024 | 2025
Gas category / pressure, rated output
e.g. 30 mbar for European units. Confirms the market version.
On the plate: PG: 30 mbar
Where the plate is
On the heater casing (type plate)
The original type plate is on the Combi heater itself. Truma says that if it is not visible after installation, the duplicate plate must be stuck on in a clearly visible place.
Truma document, page 4. Open the PDF
Duplicate type plate near the heater or service access
Look on the bed base, the access panel or the cupboard wall near the heater, or inside the back of the manual.
Truma document, page 12. Open the PDF
Side of the casing (Combi / VarioHeat photos)
Retailer photos show the Combi plate on the casing face next to the electronics, and the VarioHeat plate on the side of the housing.
Truma document. Open the document
Can't find or read the plate?
- Find the duplicate plate first: look near the heater access hatch, on the bed base, or inside the back cover of the operating instructions.
- Check the control panel. A CP plus or iNet X panel suggests a newer heater, and older Combis used the CP classic panel.
- Gas or diesel? A diesel Combi has a fuel line and a dosing pump, a gas unit has a gas pipe and a 30 mbar (EU) supply.
- Look at the outside cowl (wall or roof) and photograph it with the heater, then send the photos to us.
Questions people ask
Numbers that look alike
- Combi 4 vs Combi 6The number is the heat output in kW. Burners and some electronics differ.
- E in the name (Combi 4 E, Combi D 6 E)E means the heater also has 230 V electric heating elements. Element and wiring parts apply only to E models.
- D in the name (Combi D 4 / D 6)D means diesel. Diesel Combis share almost no burner or fuel parts with gas Combis.
- Combi D 6 AU and other regional versionsTruma publishes Australia-specific Combi documents. Treat AU and EU versions as different appliances unless a Truma list says otherwise.
- Combi Next Generation (2025)Truma issued new Combi D (E) Next Generation instructions in 2025. Give the serial number so we can tell it from earlier Combi D units.
- VarioHeat eco vs comfortThese are two VarioHeat versions listed separately in our catalogue. Read the plate.
My Truma heater is under the bed. Where is the type plate?
On the heater casing. Truma also supplies a duplicate plate that should be stuck somewhere visible near the heater. Check the access panel and the back of the manual.
What does the serial number tell you?
It identifies the heater and the series. Truma asks for it, with the model, for every service or parts request.
Is a Combi 6 E different from a Combi 6?
Yes. The E version adds 230 V electric heating elements, so it has extra parts the gas-only version does not.
Where this comes from
- Truma Combi D 6 AU installation instructions
- Truma Combi (E) CP plus ready installation instructions (34030-11800, 02, 04/2013, multilingual)
- Truma Combi (E) operating instructions (Combi 2 E UK, Combi 4 (E), Combi 6 (E))
- Truma VarioHeat (eco / comfort) operating instructions (39050-00527)
- Jacksons Leisure (UK retailer) - Label positions page (Thetford, Fiamma, Dometic, Truma, Victron)
We don't invent model numbers. Everything above is from Truma's own documents.